How it works · 3 minute read

Two routines. One box.

Use The Wash for a proper clean. Use The Top-Up when the vehicle is only lightly dusted. Both start dry and need ordinary water to rinse.

  • 30 Min · The Wash
  • 20 Min · The Top-Up
  • 0 Pressure washers

The complete wash, start to dry. Captions on — sound optional.

The three stages

Lift. Carry away. Then touch.

  1. Pre-Wash going on to a dry panel
    Pre-WashLiftLoosens road film and dirt before contact.
  2. Thick Snow Foam covering a panel
    Snow FoamCarry awayThick foam surrounds and carries loosened dirt away.
  3. The wash mitt moving over fresh foam
    Wash MittFinishA controlled contact wash for the remaining dirt.

Choose your routine

What does the vehicle need?

The Wash 30 min

Seven steps. Three stages. The complete wash the Starter Kit is built for.

  1. 01 Start dry Begin with the vehicle dry.
  2. 02 Pre-Wash Cover the dirty half first.Lower panels, sides, front and rear. Allow it to dwell before rinsing.2–3 min
  3. 03 Rinse Rinse thoroughly.The loosened grit leaves before anything touches the paint.
  4. 04 Snow Foam Cover the whole vehicle.Build a thick, even layer and allow it to dwell.3–5 min
  5. 05 Mitt over foam Work top to bottom.Use the Snow Foam as the wash soap. The mitt moves over fresh foam, not dry grit.
  6. 06 Rinse Rinse thoroughly.
  7. 07 Dry Dry with a microfiber drying towel.Panel by panel. Water left sitting is what leaves spots.

Three stages. Two rinses. One dry.

The Top-Up 20 min

Foam only. No mitt. Use this only for a lightly dusted vehicle between proper washes.

  1. 01 Start dry The vehicle must be lightly dusted.
  2. 02 Pre-Wash Cover the dirty half first.Allow it to dwell. Do not rinse yet.2–3 min
  3. 03 Snow Foam Apply directly over the Pre-Wash.There is no rinse between the two liquids in this routine.3–5 min
  4. 04 Rinse Rinse thoroughly.
  5. 05 Dry Dry with a microfiber drying towel.

No mitt. If the vehicle needs contact washing, use The Wash instead. Done in twenty minutes before dinner.

What's in the box

Three stages. One box.

  • Two assembled V2 Foam Cannons
  • Pre-Wash · 16 fl oz
  • Snow Foam · 16 fl oz
  • Wash Mitt
  • Measuring cup, a black and a gold brass nozzle per cannon, spare seals and the printed Field Guide

Need the full detail?

The whole system. On one page.

Both routines in full. The 20:1 mix and fill marks. Cannon care, storage and safety. Plus fixes for thin foam, patchy Pre-Wash and running out halfway around a truck.

  • 20:1 mixing
  • Fill marks
  • Cannon care
  • Troubleshooting
Read the Field Guide

Ready to start?

Get the dirt off before you touch the paint.

Get the Starter Kit — $79

Starter Kit · $79 · ships in 2 business days · 30-day money back